AIR-AP1810W-E-K9

·         802.1X, RADIUS authentication, authorization and accounting (AAA)

·         802.11i

·         Maximal ratio combining (MRC)

·         20-, 40- and 80-MHz channels

·         PHY data rates up to 866.7 Mbps (80 MHz on 5 GHz)

·         Packet aggregation: A-MPDU (Tx/Rx), A-MSDU (Rx)

·         802.11 Dynamic Frequency Selection (DFS)

·         Cyclic shift diversity (CSD) support

·         Dynamic VLAN or per port

·         Traffic locally switched or tunneled back to wireless LAN controller

·         Maximum transmit power: 5 dBm

·         Antenna gain: 2 dBi

·         5 GHz, gain 4 dBi

·         Management console port (RJ-45)

·         Three 10/100/1000BASE-T ports (local Ethernet ports), including one PoE out port:

◦   PoE out provides 802.3af when access point is powered by Cisco local power supply (AIR-PWR-C=, AIR-PWR-D=), or ~6.5W when powered by 802.3at, or no output when powered by 802.3af

·         One passive pass-through port RJ-45 (back to bottom)

·         DC power connector

·         Per-port status for local Ethernet ports

·         For privacy, LEDs are automatically turned off when the access point joins a controller. LEDs may be enabled to be administratively – see configuration guide.

·         Nonoperating (storage) maximum altitude: 25°C, 15,000 ft (4,500m)

·         Operating temperature: 32° to 104°F (0° to 40°C)

·         Operating humidity: 10% to 90% percent (noncondensing)

·         Operating maximum altitude: 40°C, 9843 ft (3,000m)

·         256 MB flash

·         1.4 GHz system dual-core CPU

·         Optional power supply and power injector: 100 to 240V AC; 49 to 60 Hz

·         Optional Cisco power injectors (AIR-PWRINJ5=, AIR-PWRINJ6=)

·         Optional Cisco local power supply (AIR-PWR-C= or AIR-PWR-D=)

Note: When deployed using PoE, the power draw numbers listed above include the power loss in 100m of cabling on the uplink port and 100m of cabling on the PoE out port.

·         Kensington security slot

·         Optional:

◦   AIR-AP1810W-KIT=, spacer kit to mount the access point directly on a wall where standard junction boxes are not available

◦   AIR-OEAP1810-CRD=, cradle kit to mount the access point on a desk

·         Spacer kit: AIR-AP1810W-KIT= (sold separately), includes spacer and RJ-45 jumper cable

·         Cradle kit: AIR-OEAP1810-CRD= (sold separately), includes back cover and RJ-45 jumper cable

·         Physical security kit: AIR-SEC-50= (sold separately), with 50 pcs. security screws used to secure the access point onto wall-mounting bracket, 50 pcs. RJ-45 caps and 2 pcs. unlock keys used to block physical access to Ethernet ports

·         Cisco local power supply: AIR-PWR-D= (sold separately)